Tesamorelin Reconstitution: How Much Bac Water for 5 mg and 10 mg Vials
How much bacteriostatic water to add to a 5 mg or 10 mg tesamorelin research vial, the resulting concentration, and how to store it after reconstitution.
Short answer: a 10 mg tesamorelin vial is commonly reconstituted with 2 mL of bacteriostatic water, giving 5 mg/mL; 10 units on a U-100 syringe (0.1 mL) then holds 0.5 mg. A 5 mg vial with 1 mL gives the same 5 mg/mL.
Research use only. This page covers laboratory reconstitution and concentration maths. It recommends no amount and describes no use in people or animals.
Tesamorelin reconstitution chart
| Vial | Bac water | Concentration | 10 units (0.1 mL) | 1 unit |
|---|---|---|---|---|
| 5 mg | 1 mL | 5 mg/mL | 0.5 mg | 50 mcg |
| 5 mg | 2 mL | 2.5 mg/mL | 0.25 mg | 25 mcg |
| 10 mg | 1 mL | 10 mg/mL | 1 mg | 100 mcg |
| 10 mg | 2 mL | 5 mg/mL | 0.5 mg | 50 mcg |
| 10 mg | 3 mL | 3.33 mg/mL | 0.333 mg | 33.3 mcg |
Other volumes: peptide reconstitution calculator.
How to reconstitute tesamorelin
- Check the vial mg and the batch COA.
- Bring the vial and water to room temperature.
- Swab the stoppers and let them dry.
- Add the bacteriostatic water slowly down the inside wall.
- Roll or swirl gently until clear. Don’t shake.
- Label the vial with the date and concentration.
Tesamorelin storage after reconstitution
Keep the reconstituted vial at 2–8 °C, protected from light, and avoid freezing and thawing it repeatedly. Store the unopened lyophilised vial as the supplier’s datasheet specifies, usually cold and dry. The usable period after reconstitution depends on the material, so follow the supplier’s data. The bacteriostatic water itself should be used within 28 days of its first puncture. More: how long reconstituted peptides last.
Diluent
Herbilabs reconstitution solution is 10 mL bacteriostatic water (0.9% benzyl alcohol), made in the EU, with a COA for every batch.
FAQ
How much bac water for 10 mg tesamorelin?
2 mL gives 5 mg/mL; 3 mL gives 3.33 mg/mL.
Does tesamorelin dissolve easily?
It usually dissolves with gentle swirling. If the solution stays cloudy, let it rest at room temperature for a few minutes and swirl again; persistent cloudiness is a reason to check the COA.
For research and laboratory use only. Not for human or veterinary use. Herbilabs supplies bacteriostatic water only.


